In this tutorial, we show you how to use the half-cut or Kiss Cut function in your ScanNCut Dx to cut adhesive vinyl.
Not only will you learn how to cut Adhesive Vinyl and also how to use the transfer paper to transfer your designs.
Watch the video tutorial below:
Disclaimer: We were fortunate to be sent a bundle of Adhesive Vinyl and a roll of clear Transfer paper from Kassa. And although we received these items at no cost, our review is an honest assessment of how we found the product.
The 60 sheet adhesive pack comes with 8 vibrant colors in a gloss finish plus the black and white sheets that are in a matte finish. So there is plenty of variety for your scrapbooking and labeling projects. The roll of clear Transfer Paper also comes with some bonus sheets of adhesive vinyl.
One thing we really like is that the sheets measure 12″ x 12″ which means they are ideal for use in your Brother ScanNCut. This is great if you don’t have the roller accessory for your ScanNCut DX.
Both the adhesive vinyl and the transfer paper are easy to use and come with full instructions.
Place it on the backing with the adhesive side down towards the backing sheet. Then the next time you have a design in the same size you can reuse that piece of transfer paper rather than cutting a new piece.
12″ x 12′ Kassa Vinyl Sheets – 8 Glossy Colours & 2 Matt Colours.
The pack comes with a Bonus Squeegee for getting out air bubbles if needed.
Lucy says
I followed the amazon store link (and opened with my amazon account) but there are no buy options for Aussie buyers. Obviously the link and discount code is only good for your US based followers ?
Alanda says
Yes, you’re right Lucy, it only applies to the US. I think the postage on this would be a killer to Australia. They sent us the pack and it was quite heavy.
Joanne Short says
Hi, I’ve tried to subscribe by typing in my standard gmail account a few times and I keep getting an error message telling me to use another email address.
Jo
Alanda Craft says
Hi Joanne, we don’t appear to have you registered on our system. It may have been a glitch in the system. Maybe try subscribing again on this page https://www.alandacraft.com/subscribe/.
Kim says
When you get the error message after you put in your email address make sure to backspace one time. For some reason it puts a space after the .com. if you backspace until the black line flashing is right after the m it should work fine. Just speaking from experience. Lol. Hope this helps.